DxPatrol GPS V2.1 controlled oscillator 10MHz

An affordable GPSDO (GPS Disciplined Oscillator) with 10 MHz precision clock designed for the most demanding microwave enthusiasts. 

The high-contrast OLED display provides information about position, SAT status and time. The receiver supports GPS, Glonass and Galileo.

The voltage supply can be 8 - 14 V.

On the back of the housing, in addition to the connector for the GPS antenna, there are 3 additional SMA outputs for sine waves (A+B+C ~ 7 dBm), as well as an SMA output for square waves.

This GPSDO, version 2.0, is programmed in hotstart mode. This means that even without an antenna and without a GPS signal, it will still provide a reliable and accurate 10Mhz signal at the outputs.

However, since an internal OCXO (Oven Controlled Oscillator) is used, the internal heater needs about 5 minutes to reach the operating temperature - 50ºC. The resulting heating of the housing is completely normal.

We have a new model improved by Luis, CT1DMK.
Luis redesigned our Loop Filter with new architecture PLL so we manage to reduce the lock delay for only 1 minute.

Performance data:
Duty cycle 50%
Phase noise @ 1Hz - 80dBc/Hz
Phase noise @ 10Hz - 120dBc/Hz
Phase noise @ 1KHz - 145 dBc/Hz
Phase noise @ 10KHz - 150 dBc/Hz
Second harmonic < 51 dBs
Third harmonic < 56 dBs
Operating temperature range 0 - 75º C
Operating temperature ~ 50º C (OCXO) 

New Oled Display data presentation
Ultra High accurate UTC Clock
Local GPS coordinates presentation
Number of satellites in range
Wait / Lock indication.
GPS, Galileu, Glonass receiver
GPS antenna 3m long  cable included